Dimensions
1 U
105 mm deep
Current Draw
40 mA +15V
40 mA -15V
0 mA 5V
Price
$222 Price in €

Available as an assembled Module and as a DIY project.

No info about availability.

Voltage controlled LFO

This is a versatile yet easy to use voltage controlled low frequency oscillator module that can also be used as an audio VCO over a useful range.
The unit features sinusoid, sawtooth, ramp, triangle and square outputs. All are available simultaneously. A sync input is available to reset the waveforms to a fixed point.
The module features two CV inputs. One is fixed at 1V/octave. The other CV input is controlled by a single pot on the front panel. When the pot is turned right of its central position, the pot acts as a normal attenuator; increasing the sensitivity of the CV input to a maximum of 0.5V/octave. Left of centre, the pot will act in inverting mode. Fully anti-clockwise the input will respond to -0.5V/octave.
A tricolour LED indicates the output status.

Specifications

The VC-LFO has an operating range of lower than one cycle every 5 minutes to over 7 kHz from the front panel controls.
The range can be extended with external CV inputs. The maximum frequency of the VC-LFO is well over 25kHz.
When used as an audio rate VCO the usable range that conforms to 1V/octave (to +/-2cents) is over six octaves from approximately 32Hz to 2kHz. This is none too shabby for a low frequency oscillator. For accurate musical use over 2kHz we recommend that you use the Oakley VCO.
Sync input requires a fast rising gate exceeding 4V when active, or at least 2V peak pulse or sawtooth waveform.


submitted Jan 6th 2015, 07:44 by Stereotactixxx | last Change Oct 10th 2018, 05:32 by wiggler87830
Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.

Canada

Lower West Side Studio

USA

Synthcube

These merchants probably sell this module. Huh?