Module is available as a DIY project only.
This Module is a prototype or in a concept phase.
517S VC High/Low Pass Filter with Synthesizers.com Q110 PCB installed
Besides being easy to do, it is a nondestructive modification and easily reversed. (it will likely void your warranty on both modules though! eek! hihi ) The steps are basically:
Remove the Q110 PCB from the module
Remove the bottom two screws for the top PCB of the 517
Add two stand-offs where you removed the screws from the 517
In the top two holes of the Q110 PBC add two nylon threaded spacers the same height as the stand-offs
Attach the Q110 PBC to the new stand offs you put in the 517
Remove the jumper on the 517's input header K3
Place the jumper on the top two pins of the three pin head on the Q110 PCB where the Q110 volume pot used to be.
Make a little 2 pin MTA 100 jumper and connect the lowest 2 pin header of the Q110 PCB to the 517's input header K3
That's it! thumbs up Here's a little Instagram test, not very comprehensive, just FWIW:
https://www.instagram.com/p/BUoiiWiDfMD
Pearl S-800$33.15
GK W302$95.34
Wampler Tumnus Deluxe
Wampler Tumnus
Fender Stratocaster
PRS SE Silver Sky Ever Green 2021