Michelangelo Nunchuk Controller

play your Eurorack with a nunchuk controller

Michelangelo asks, “Why play a synthesizer with a keyboard or sequencer when you can play it with a nunchuk controller or two?”

A nunchuk controller has a 2D joystick, a 3D accelerometer, and 2 buttons. The joystick and accelerometer axes map to 5 bipolar control voltages, and the 2 buttons map to gate outputs.

A bonus “saw” output is a software generated low frequency saw oscillator complete with aliasing. Its frequency is controlled with the y-axis of the acceleromter, and it can be re-triggered with the C button.

The 6 knobs are attenuverters for the control voltage outputs with a maximum range of +/-10 volts. This allows switching the polarity of the controls and scaling the CV range. The gate outputs are +5 volts when on and 0 volts when off.

The module is 16 hp wide and 31 mm deep.

NOTE: There is a nunchuk controller coming out the bottom of the module that does not fit in the panel picture. Please see sonoclast.com for a fuller picture.

http://sonoclast.com/products/michelangelo-nunchuk-controller-eurorack-module/