Module is available as a DIY project only.
This Module is discontinued.
LFO, Slew limiter and Envelope generator by KYMATICA DEVICES
(See LFO/SLEW/ENV 1.1 for the current version)
One module, three functions.
The LFO is a typical standard LFO with saw-tri-ramp shape, as well as
a pulse/square output.
The slew limiter allows linear or typical RC-curve slew limiting.
The envelope generator has two modes: ASR and ADSR. The sustain knob
controls the S level. The shape knob controls the balance between A
and D/R. So D and R has the same time, just like on the minimoog. In
ADSR mode, the attack phase always finishes even if the trigger/gate
is shorter, this makes it possible to use as a clock divider or
"subharmonic generator". ADSR mode with S at max gives an ASR but
where A always finishes, S at min or if gate input is shorter than A
time, gives an AR where A always finishes.
So the shape knob affects the waveform shape for all three functions.
Same with the rate knob and range switch.
The lin/log switch affects both the slew limiter and envelope
generator. (it needs to be in LIN position for the LFO).
The RISE/FALL outputs put out a high gate when the output is rising or
falling, and works for all three functions.
