Module is available as a DIY project only.
This Module is currently available.
LFO, Slew limiter and Envelope generator by KYMATICA DEVICES
One module, three functions.
The LFO is a typical standard LFO with saw-tri-ramp shape, as well as a pulse/square output.
The slew limiter allows linear or typical RC-curve slew limiting.
The envelope generator has two attack modes: Gated, where the attack phase is cancelled if gate goes low, and Triggered, where attack phase always finishes until it reaches the target peak voltage. The sustain knob controls the S level. At 0% it gives an AD envelope, at 100% an ASR. The shape knob controls the balance between A and D/R. So D and R has the same time, just like on the minimoog.
In Triggered attack mode, the attack phase always finishes even if the trigger/gate is shorter, this makes it possible to use as a clock divider or "subharmonic generator".
So the shape knob affects the waveform shape for all three functions.
Same with the rate knob and range switch.
The lin/log switch affects both the slew limiter and envelope generator. (it needs to be in LIN position for the LFO).
The RISE/FALL outputs put out a high gate when the output is rising or falling, and works for all three functions.
