V-010 Voltage Limiter

Dual Safety voltage limiter module

From the top down:
Ch1 CV input + limit LEDs
Ch1 CV output (limited)
Ch2 CV input + limit LEDs
Ch2 CV output (limited)
Top limit voltage switch

This is the dual voltage limiter for safe patching Eurorack CV signals to an external guitar pedals / processors to avoid freezing pedal / processor (in worst case even burning input). Bottom voltage limit is always 0V, top voltage limit is switchable 3.3V / 3.0V / 5V (setting is common for both channels). If input signal reaches limits set (0V and top voltage) it will be held at limit (shown on LEDs). Input signal should be scaled somehow before reaching V-010, say U-012 Dual attenuverter can be used as input module (CV scaling, inversion and DC shift) to modify almost any signal into range required by pedal / processor.

Width: 4TE/ 4HP/ 20mm.
Depth: 46mm /1,8″ max.
Current: 15mA max.
Power cable included.

http://ladik.ladik.eu/?page_id=3664