KNIFE (14HP Blades Clone)

Dual Multimode Filter

**TLM Audio introduces the classic mutable series.

KNIFE is 14HP version of the Mutable Instruments Blades module.
It is built, calibrated and tested with the highest quality standarts. **

Features
An essential overdrive circuit
A CV-controlled overdrive stage precedes each of the two filters.
Overdrive response continuously adjustable between soft-clipping and 2-stage wavefolding.

Two rich multimode filters
Clean 2-pole (12dB/octave) state-variable design.
CV-controlled filter response, continuously variable between low-pass, band-pass and high-pass.
CV inputs with attenuverters for cutoff and resonance.
Unattenuated frequency CV input, calibrated for 1V/Oct tracking.
Clean self-oscillation across the audio range, extending into very low frequencies, with constant amplitude.
Modulating the filter response is akin to modulating the phase of the self-oscillation tone.

Unique routing possibilities
Continuously variable (and CV-controlled) routing from single to parallel to series.
With a signal patched into filter 2's audio input, the routing knob and CV act as a crossfader.
Filter 2's cutoff can be set relatively to filter 1's cutoff.

Specifications
Fully analog, based on the V2164 quad VCA chip.
Frequency knob range: 8Hz to 18kHz.
Audio input impedance: 30k.
DC-coupled audio inputs.
Filter mode CV input impedance: 50k.
Other CV inputs impedance: 100k.
All CV inputs handle audio-rate modulations.

https://www.tlm-audio.com/eurorack