S-075 Burst generator

Burst generator

S-075 Burst generator module for Eurorack / Doepfer A100 system

From top:
Number of bursts knob + CVin jack, LED lights at odd numbers
Spacing knob + CVin jack
Trigger/gate input + LED
Gate output + LED
Burst output + LED

Internal jumper settings:
upper jumper sets 1-8 bursts (jumper removed) or 0-8 bursts (jumper set)
lower jumper sets output trigger/gate length fixed 2ms (jumper removed) or half of spacing (jumper set)

Minimum spacing about 3ms (8 bursts pass in about 24ms)
Maximum spacing slightly over 1s (8 bursts pass in about 8s)
Gate output is active while burst is passing.
Rising edge of trigger input restarts new burst if current burst is passing.
Knobs works as attenuators for input CV if jack is plugged in.

Width: 4TE/ 4HP/ 20mm
Depth: 40mm /1,6″ max.
Current: 25mA (from positive supply only)
Power cable included

http://ladik.ladik.eu/?page_id=1644