Comparator and Gate/Trigger Delay
http://circuitabbey.com/tripfire.html
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Comes with power cable and screwsThe Trip/Fire is a very handy dual utility Euro Rack module in 4HP. The top half is a full featured comparator, and the bottom module is a multi-mode trigger/gate delay. It is greatfor creating new rhythms, triggering envelopes, and all kinds of modular experiments!The comparator uses a reference level to compare against the input. If the input is higher than the reference then the output goes high. The reference source is an external inputpassed through an attenuverter. If no source is plugged into the REF input an internal source is used.The output of the comparator is normaled to the input of the Gate/Trigger delay, meaning that any gates derived from the comparator pass down to the trigger/gate delay unless another source is plugged into the trigger/gate delay input.The delay section is an event/edge recorder with one trigger delay mode and 2 gate delay modes. Trigger delay senses trigger inputs and delays them before sending to the output.The first gate mode outputs a delayed gate open input but outputs a gate close without delay. The other gate mode delays both the gate open and gate closed input. The delay range is about 1 second and jumper settable to about 8seconds.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.