ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.
Updated edition of the MOTM-300 analog VCO
http://synthtech.com/eurorack/E300
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
New in BoxSelling as used to comply with Reverb’s listing policiesPhat, vintage analog soundOne of the most stable VCOs out thereDesigned/engineered in collaboration with Dave Rossum of Rossum Electro-MusicFully analog discrete circuitry Assembled by Paul Schreiber himselfRare, discontinuedFrom Synthesis Technology:OverviewThe Synthesis Technology E300 Ultra VCO is an analog oscillator based on the MOTM-300 5U module, with an updated design engineered in collaboration with Dave Rossum of Rossum Electro-Music.The E300 uses modern temperature-controlled exponential converters without the expensive MAT-02EH + Tempco found in the MOTM-300. It also incorporates variable HFT (High Frequency Tracking) for a wider, more accurate 1V/Oct input. The SYNC circuit is a simpler hard sync type, with accurate detection of any waveshape/frequency used. There is an added -1OCT/-2OCT sub-octave squarewave output, which is phase-aligned with the sawtooth.The VCO core is a new sawtooth-based circuit with improved linearity and a unique saw-to-triangle converter with no glitch in the transition peaks.Just like the MOTM-300, the E300 is designed to be the best tracking analog VCO available (over 10 octaves) with the lowest temperature drift (typically less than 0.1Hz over a 24hr period).SpecsSPECSHeight3U (128.5mm)Width14hp (70.8mm)Depth32mmPower16-pin Eurorack (55 mA from +12V, 40 mA from -12V)CV Range10Vpp (-5V to +5V)Audio Output10Vpp nominal +-0.35VFrequency Range15Hz to 19KHz (no CV input)PANEL CONTROLSCOARSE/FINESets the initial VCO pitch with no CV appliedPULSE WIDTHModifies the width of the PULSE output FM 1/2Attenuators for the FM inputs. FM 1 can be switched between EXP (exponential) and LIN (linear) FM. FM2 is linear.SUB SWITCHControls whether the sub-oscillator output is 1 or 2 octaves below the initial oscillator frequency.INPUTS AND OUTPUTS1V/Oct1 volt per octave control for the initial VCO pitchFM 1VCO frequency modulation input with attenuator Can be switched between EXP (exponential) and LIN (linear) FM using the toggle switch.FM 2VCO frequency modulation input, exponential FM, with attenuator.SyncReset VCO frequency when input signal exceeds +1.7VPWMPULSE width modification input, with attenuator.SINE, TRI, SAW, PULSEThe primary outputs of the oscillatorSUBThe sub-oscillator output. Can be switched between 1 or 2 octaves below the initial oscillator frequency.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.