Stereo Reverb & Delay with Tap Tempo
https://www.earthquakerdevices.com/avalanche-run
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Avalanche Run V2 - excellent condition! Comes with original box, manual and sticker.The Avalanche Run is a dreamy stereosonic exploratory multi-tool that includes up to 2 seconds of delay time, reverse delay, tap tempo with subdivision control, switchable true bypass or buffered bypass with 5 different tail lengths (including a sound-on-sound style lo-fi looping mode) and an assignable expression control that maps the expression jack to a control of your choice, including the toggle! The delay section allows tweaking from tape emulation to bucket brigade styles with a twist of the wide-range Tone control. The cavernous, plate-style reverb has just a touch of modulation similar to the one found in our precious Dispatch Master only more lush with an adjustable Decay. Otherworldly reverse delay and dynamic swelling reverb settings are accessible through a 3-way toggle switch. And that’s just the beginning...Dimensions: 4.65 x 4.15 x 2.25 in. (118 x 105 x 57 mm) with knobsCurrent Draw: 410 mAInput Impedance: 1 MΩOutput Impedance: 100 ΩS/N Ratio: 115dB typical24-bit 96kHz A/D & D/A convertersAll analog dry signal pathAll digital wet signal path with 20Hz – 20kHz frequency responseExpression Jack: The expression jack is located on the west side of the pedal. It is a TRS jack with the tip acting as the wiper.We recommend using a Moog expression pedal with the output adjustment knob all the way up.We cannot guarantee any other expression pedal to work with the Avalanche Run.Flexi-Switch® Technology: This device features Flexi-Switch® Technology! This relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching.Since the switching is relay based, it requires power to pass signal.For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch the effect will be bypassed.Power: For best results, please use the included 9v centre-negative 1-amp DC power supply.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.