Bass Effektpedal
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Fully tested, in excellent all round condition. There are couple of small dings to case. Requires a standard FX pedal 9v power pack, not supplied.The Keeley Bassist Compressor is a high-fidelity compression and limiting pedal designed specifically for bass guitars. It’s built around the exotic and extremely high-fidelity THAT Corp. 4320 chip, making it a studio-grade compressor in a stompbox format.Key FeaturesHigh-performance Voltage Controlled Amplifiers (VCAs)On-board true-RMS detectorUltra-high-performance op-ampsCompression Ratio Control (1:1 to hard-knee limiter)Threshold Control (adjustable peak detection)Gain Control (boost or compression)Threshold Indicator lightLow noise and high bandwidth (over 20 KHz)CharacteristicsMusical and transparent compressionSuitable for active pre-amps and line-level input signalsNo coloration or pumpingAllows for precise control over compressionCan be used as a limiting amplifier to prevent speaker clipping and distortionSettings and UsageCompression Ratio: Adjust to desired level of compression (1:1 to hard-knee limiter)Threshold: Set to detect peaks in your signal and limit distortionGain: Use as a boost or compression controlAttack and Release times: Varying depending on program content (adaptive)
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.