Available as an assembled Pedal and as a DIY project.
This Pedal is currently available.
DSP-based chorus / tap delay / plate reverb
Stasis Leak is a 48kHz DSP effects pedal, providing a choice of chorus, plate reverb and tap tempo delay. Stasis Leak is based around a Belton ABE-FX sub board, which in turn is based around a Coolaudio V1000 chip. Designed to fit in a 1590BB enclosure.
Tone control
This knob works on each of the three different effects as a simple lowpass filter, cutting the highs in the effected signal, and helping to provide definition between the dry and wet signal.
Wet control
This knob controls the amount of effected signal that is mixed with the dry signal. Dry is always 100%.
Tap
This function applies to the delay effect, where it may be used to set the delay time.
Time & Density
Chorus / Delay / Reverb
Time knob LFO rate / Time sub-divisions* / Pre-delay
Density knob Depth / Repeats / Decay
Delay time (50 – 1000 ms) – Tap more than once within 1 second to set, LED blinks at quarter-note tempo, and the time knob is divided into 4 tempo subdivision:
0-25%: 8th-note triplet
25-50%: 8th-note
50-75%: dotted 8th-note
75-100%: quarter-note
The chorus section consists of two parallel sections which are 90 degrees out of phase with each other. This results in a rich chorus effect. These two sections are mixed internally and output as a mono signal.
