Lots of interesting thoughts and good suggestions from @HGsynth.
But be careful, you should not ideally exceed 640mA on +12V and on -12V (per each row) in a RackBrute 6U, that is to say 80% of the 800mA available (for +12V and the same for -12V, there are four separate circuits of 800mA in two rows): and this in order to leave enough headroom for voltage peaks!
However the data sheet of the rack proposed here (in MG) indicates 743mA on the row2 (for +12V), which would be very risky...Also, you only have 12 slots in the row2, and I see here 13 modules.
-- Sweelinck
physical location does not necessarilly need to reflect where power is plugged in... longer power cables are available (& easily made)
"some of the best base-level info to remember can be found in Jim's sigfile" @Lugia
Utility modules are the dull polish that makes the shiny modules actually shine!!!
sound sources < sound modifiers < modulation sources < utilities