My questions is: if I were to plug an attenuverter into the sequencer resets, can I turn it from low to high to trigger them? My intuition is trigger inputs are triggered by the voltage going from below some threshold to above the threshold (maybe with hysteresis to prevent double triggers), so I don't need a dedicated trigger signal necessarily, I just need something I can make go from low to high voltage.
Do I have the right idea, or in practice is it better to use a dedicated trigger signal (a short pulse) to avoid strange behavior?
adamj
Yes, this would work. But there is a much simpler way: simply patch a cable into the reset input and press the tip of the other end with your thumb ;)
That’s a handy hack !