User Posts

FIELD KIT:
Field Kit Input 1 - Olympus S925
Field Kit Input 2 - Sony TCM450
Field Kit Input 3 - Korg Monotron
Aux Out - Korg Monotron
LFO on Low-Range (Triangle)

FIELD KIT FX:
Freq Shifter Mode
CV1 - Roll o Decks
CV2 - LFO
CV3 - LFO attenuated

Modulations:
Amount/SSR - CV3
Cutoff - CV3
TIME - CV1
TRESH - CV2

Input 1 - Freq Shifter Out
Input 2 - Delay Out
Input 3 - Spring Out
Input 4 - Multiplied Signal from the Sony Dictaphone

EDITED Oct 19th 2018, 20:48

LFO Triangle Wave at Audio Rate
Field Kit FX is in Freq. Shift Mode
Modulations:
Amount - CV 1
Control - CV 2
Time - CV 1
Cutoff - CV2
(Patch also sounds pretty good without the Envelope Follower on CV2)
I used the special cable from the Expansion Pack to route the Delay Feedback into the Freq. Shifter.

Pretty basic patch this time.
No modulations going on here.

CV Interface Input 1 = Roll O Decks (following the speed of the LFO)
CV Interface Input 2 = Envelope Follower
CV Interface Input 3 = LFO Attenuated
CV Interface Input 4 = LFO Unattenuated

LFO in Low Range

Master Out (guitar loop) -> Loop/Freq Shifter Intput & Input 4 VCA Mixer
Loop/Freq Shifter Out -> Digital Delay In & Input 1 VCA Mixer & Spring Rever Input
Delay Out -> Input 2 VCA Mixer
Spring Reverb Out -> Input 3 VCA Mixer

CV Routings (I was varying them during the video, so try around a bit):
Amount/SSR -> Roll o Decks
Control/Crush -> Envelope Follower
Delay Time -> LFO (attenuated)
Reverb Cutoff -> LFO (attenuated)
Thresh -> LFO

EDITED Oct 13th 2018, 09:16